QuickFit VersaHeat R
Column heater for Evosep One and EASY-Spray
Plug-and-play column heating for capillary columns that reaches the target temperature in under a minute and holds it within 0.5 °C.
Fast ramp-up
Ready before your next injection
VersaHeat R heats the column through a resistor-based contact board and is powered and controlled through the EASY-Spray™ jack. No extra controller, no extra cables on the bench.
< 1 min
To target temperature
0.5 °C
Accuracy
25 %
Lower back pressure on Evosep One
Why column heating matters
Small temperature changes, big differences
In nanoLC-MS, a few degrees change retention times, peak shapes and reproducibility. A column heater keeps every run the same.
Consistent retention times
Less drift from changes in room temperature.
Sharper peaks
Optimal mobile phase viscosity and better resolution.
Faster loading and washing
Higher flow rates at the same pressure.
Longer columns, smaller particles
Room for high-efficiency separations.
More uptime
Shorter equilibration and column wash.
Stable from lab to lab
Less effect from air conditioning and room shifts.
Compatibility
Plug and play with Evosep One and EASY-Spray
- Validated on Evosep™ One with 25 % lower back pressure
- Plug and play with Thermo™ EASY-Spray™
- Fits a large number of column arrangements
- Low-flow, capillary and micro-flow LC-MS
- Compact, lightweight and easy to integrate
Working with µPAC columns?
See VersaHeat S
Our heater for Thermo Scientific µPAC Neo columns, powered through the EASY-Spray jack.